| 形容： |
押出しライン APV 125MP compounding line
中古機
Extruder is missing electronics and it is not in running condition.
Barrel 30D
The barrel was opened for inspection of the liners and shafts, the
hydraulics function correctly.
Liner 1.
Feed, 2.5D good condition
Liner 2.
Inter, 5.0D good condition
Liner 3.
Inter, 5.0D good condition
Liner 4.
Inter, 5.0D good condition
Liner 5.
Inter 5.0D good condition
Liner 6.
Inter 2.5D good condition
Liner 7.
XLT Discharge 5D good condition.
Feed and return lines were removed and compressed air fed into
circulation blocks. All blocks were found to have good
flow.
Pipework is in good condition with all solenoids present.
All control thermocouples and melt thermocouples are in place but
could not be tested due to condition of electrics.
All the heaters are in place but could not be tested due to the
condition of electrics.
The barrel is in very good overall condition.
Shafts
All elements are in good condition with very little visible wear.
Customer has numerous spare elements and 2 sets of new shafts
Spares held by customer,
Feed Screw 1D 1D 18 off
Feed Screw 1.5D 1D 14 off
Feed Screw 0.75D 1.5D 6 off
Feed Screw D/4 1.5D 4 off
Tight Helix Feed Screw 1D 5 off
Feed Screw â XLT transition 1.5D 1D 5 off
Orifice plugs D/4 4 off
Paddles D/4 69 off
XLT FS 117mm 3 off
XLT FS 156.25mm 6 off
XLTD FS 156.25mm 3 off
End pins 2 off
Set of E661673 shafts 2 off
Gearbox
The motor coupling and the shaft couplings were disconnected from the
gearbox.
No excessive backlash, end float or radial movement is present in the
input or output shafts.
Timing is ok.
There are no visible oil leaks.
Electrical panels
The extruder electrics/electronics have been badly vandalized and as
far as I can see very little can be salvaged and a
new panel would be needed in order to run the extruder and feeders.
The original panel controlled 8 feeders and all ancillary equipment
and ran on Siemens S5 see below photos.
seller offer No. resale
P91004100
|